Piotr JAREMEK
Analytical estimation of drilling bits equipment wear
In the article are presented some results of tricone bit equipment wear tests basing oneself on worked out the model of tribological contact of this element with mining undisturbed soil. To confirm the validity of the model the numerical calculation of parameter mentioned above were performed.
Analiza propagacji rysy w uwarstwionym materiale kruchym
W artykule przedstawiono wyniki analizy dotyczącej wpływu asymetrii wytrzymałości warstw, uwarstwionego materiału sprężysta- kruchego na mechanizm propagacji rys, w trakcie oddziaływania obciążenia mszczącego. Analizą prowadzono z wykorzystaniem Metody Elementów Skończonych w analizie naprężeń oraz metody traconych elementów do modelowania propagacji szczeliny. W analizie wykorzystano kryterium PJ [l] zniszczenia materiału, który użyto do opisu materiału o właściwościach zbliżonych do betonu.
Analiza wpływu nacisku osiowego na zużycie uzbrojenia świdrów gryzowych
Przedstawiono wyniki badań zużycia uzbrojenia świdra trójgryzowego w oparciu o opracowane modele kinetyki kontaktu tribologicznego z urabianą calizną. Przeprowadzono rozwiązanie numeryczne zagadnienia, gdzie oszacowano zużycie uzbrojenia na poszczególnych wieńcach gryzą w zależności od wielkości nacisku osiowego działającego na przewód wiertniczy. Wyniki rozwiązania przedstawiono na wykresach.
Analysis of the crack propagation in laminar brittle material
In this paper an analysis has been presented concerning the influence of the strength asymmetry in laminar elastic-brittle material on the crack propagation mechanism when a destructive load is applied to a sample. The Finite Elements Method (FEM) was applied to stress analysis as well as the "lost" elements method being applied to the simulation of crack propagation. The analysis used the PJ[l] material failure criterion which was used for the description of a material which has properties close to the properties of rock or concrete.
Axial thrust effect on drilling bits equipment wear analysis
In the article are presented some results of tricone bit equipment wear tests basing oneself on worked out the model of tribological contact of this element with mining undisturbed soil. To confirm the validity of the model the numerical calculation of parameter mentioned above with regard to axial thrust were performed.